Atomic Z2: How to remove exhaust tee?

[stuartv]

I got an set of Atomic Z2 regs and I got the wide exhaust tees to go with them.

I cannot figure out how to get the stock tee off. I searched here and found one explanation, but it did not make sense to me.

I understand it's just a matter of using a small screwdriver to pop it off, but I am not sure where to apply said screwdriver.

Help? Please?

 

[happy-diver]

I don't know but tend to use nylon stuff including bone tools on plastic

including other designs fashioned from cutting boards also with heat

by the way, You seriously can't go past FCP EURO for stuff

 

[stuartv]

I don't know but tend to use nylon stuff including bone tools on plastic

including other designs fashioned from cutting boards also with heat

THANK YOU!!

So easy, once you see the correct spots to pry a little bit! A picture really is worth 1000 words.

 

[Scared Silly]

As one pries up (do not twist), there is a very noticeable click when it releases. Once you hear the click, do the same on the other side.

 

[stuartv]

I don't know

Any chance you have a similar lack of knowledge on the Atomic 1st stages?

Also, what's up with the FCP Euro link? Car parts?

 

[stuartv]

As one pries up (do not twist), there is a very noticeable click when it releases. Once you hear the click, do the same on the other side.

I used a screwdriver the same width as the slot. A gentle twist on each side was all it took. It was harder to pop the wide tee on.