ontdiver
Contributor
I attempted to attach an XS Scuba pocket with a neoprene backing to my neoprene wet suit using Mcnett "Urethane Repair Adhesive & Sealant". I placed sufficient weight over the pocket and waited approximately 24 hours. Unfortunately, because I had not taken into consideration the overall design of the pocket, the sealant was not able to bond properly.
I was able to remove the pocket and am now wondering about Plan B. Does anyone known whether it is possible to use Mcnett "Seal Cement" on top of the urethane sealant, and if so, what should I do to prepare the surfaces that have dried urethane sealant on them? (I have asked McNett for advice on this but have not received any feedback.) Thanks
I was able to remove the pocket and am now wondering about Plan B. Does anyone known whether it is possible to use Mcnett "Seal Cement" on top of the urethane sealant, and if so, what should I do to prepare the surfaces that have dried urethane sealant on them? (I have asked McNett for advice on this but have not received any feedback.) Thanks