RICHinNC
Contributor
I am having problems with my wing valve connections. Every time I unscrew either the lower dump valve or the corrugated hose connection
.it unscrews from the part that is INSIDE the wing.
To be sure we are all on the same sheet of music ..there are three parts that screw together. There is a threaded part inside the wing. It sticks out and another part screws onto that. This part has threads on the inside of the ring to screw onto the part in the wing and threads on the outside so that the cap or hose can then screw on to it. And, finally, there are the hose and pull cap pieces.
It is the most inner and middle piece that keeps coming undone.
Is there anything I can put on the threads to keep that from happening? I super clean after each dive so it isnt accumulation that is causing the problem.
Ideas??
To be sure we are all on the same sheet of music ..there are three parts that screw together. There is a threaded part inside the wing. It sticks out and another part screws onto that. This part has threads on the inside of the ring to screw onto the part in the wing and threads on the outside so that the cap or hose can then screw on to it. And, finally, there are the hose and pull cap pieces.
It is the most inner and middle piece that keeps coming undone.
Is there anything I can put on the threads to keep that from happening? I super clean after each dive so it isnt accumulation that is causing the problem.
Ideas??