Sorry for the tech glitch. It did work however I got your answers, thank you.
Good to know. Thanks.
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
Sorry for the tech glitch. It did work however I got your answers, thank you.
Is this your project? AMPHIBIO — Jun Kamei
It's... a pretty industrial design...
Be aware that people on this forum have a very high bar for their sniff-test of new revolutionary underwater breathing technology, and have seen a lot of wild claims from heavily-hyped failed startups over the years. Not that groundbreaking innovation isn't possible, but the technical people around these parts are going to demand extraordinary evidence for extraordinary claims and probably try to fight you.
The idea of 3D printing "perfectly packed" blocks/matrices of sofnolime might be sorta interesting. Pulling enough dissolved O2 out of the water to supply a human is HARD to say the least.
Something wrong in your math. One liter of oxygen at 1 bar, 20°C weights approximately 1.314 grams. As we need 2 liters/minute, that is 2.63 grams. Not 13 milligrams...I am not sure .... what the tech people would do but
According to this article Dissolved Oxygen - Environmental Measurement Systems the best we can think of extracting from water are about 14 mg/l of oxygen.
As each reb diver knows we need about 1-3 l/min of oxygen in normal conditions. Let's assume 2 liters min at 1 bar. Using the standard gas equation PV=nRT n=PV/RT and assuming T = 300 K it would give us .00080225 mol/min of oxygen which is about 13 milligrams per minute. So with a flow of 1 litre per minute of water the requirement of oxygen could be fulfilled ... if we assume 100% efficiency of oxygen extraction and in best conditions. We would also need such flow (pump? Batteries?) BUT
The problem is where would we get the nitrogen to fill our lungs? And do we have counterlungs to empty our lungs into or would we vent gas offboard? In such case the requirement would vary dramatically and become rapidly unsustainable:
Let's say we have counterlung so we only vent CO2. In such case diving to 10 meters and assuming 3 liters tidal volume and 5 liters vital capacity, descending to 10 meters (2 bar) would require to extract from water 5 liters of gas at 1 bar which joining the 5 liters already in the lungs (?) would make up the total 5 liters at 2 bar.
according to this site Nitrogen (N) and water the solubility of nitrogen in water is 20 mg/l (this will also vary with depth and temperature but lets keep it simple) therefore to extract 5 liters at one bar once again using the ideal gas state law (we need to remember that 1 mole in normal condition is 22.4 liters so is about one querter to one fifth) we would need about 0.22 moles which is 3.125 grams.
Once again to extract 3.125 grams of nitrogen from water we would need 156 liters of water with 100% efficiency. Pretty much a water jet while descending.
Finally if I vent the gas instead of recycling it, I would need to replenish (at 10 mt) my tidal volume times the pressure; so at 10 mt 6lt/min at 20 mt 9 lt/min and so on so I would need a water jet pumping several hundred liters of water per minute, depending on depth, through the device.
I am not going into He and narcosis
The gills works because they ensure gas exchanges directly between blood and water, there are no lungs to be filled. I do not think I would like to have my blood rerouted through the device ....!
I think it should be marketed as a scooter also!
Just to have fun!
Cheers
Sorry Angelo you are right.Something wrong in your math. One liter of oxygen at 1 bar, 20°C weights approximately 1.314 grams. As we need 2 liters/minute, that is 2.63 grams. Not 13 milligrams...
For extracting 2.63 grams per minute, you need to process 200 liters of water. Almost unfeasible, and requiring A LOT of energy.
Last point: I suppose that a standard cylinder full or normal compressed air is assumed to be always available (AND TO BE USABLE AS A BAILOUT). The rebreather should just take care of providing the oxygen being used and to remove the CO2 being generated.