2859tim
Registered
What is the correct compressor oil level at siteglass for a Stewart Warner Southwind 4.0 CFM...MODEL 3800203-5....FSN 2H4310-165-4885.
Presently the siteglass is 95 to 100% covered while compressor is not running and level. During fill operation at 3500RPM, siteglass is approx 60 to 65% covered. Don't have a manual but was told by a person who had another SW 4.0 that siteglass should be 3/4..If I fill oil so that I show 3/4 SG at full RPM then I seem to get a small amount of oil seeping from crankcase breather funnel cap but does not happen at 65% level...This is an onboard boat scuba fill application...Thanks in advance for any advice.
Presently the siteglass is 95 to 100% covered while compressor is not running and level. During fill operation at 3500RPM, siteglass is approx 60 to 65% covered. Don't have a manual but was told by a person who had another SW 4.0 that siteglass should be 3/4..If I fill oil so that I show 3/4 SG at full RPM then I seem to get a small amount of oil seeping from crankcase breather funnel cap but does not happen at 65% level...This is an onboard boat scuba fill application...Thanks in advance for any advice.