First Problem: I have been losing my Air Pressure and getting a failed message. I have a back-up, so it does not pose a problem, but is annoying. I just went down to three battery bars. Is there a correlation between air pressure failures and minimal loss of battery power? I am going to change over the batteries anyway, but just wondering.
Secondly, the computer is not allowing me to swith gasses if my air pressure is less than 750psi, which is where I have my alarm set. This is a problem, because it is not uncommon to have just under this amount by the time I am ready to switch over. In the Vytec manual it mentions that it won't allow you to switch gasses if doing so would create a PPO that violates your setting. However, it does not say anything that I can find about not allowing a switch due to the volume in your primary tank.
Anyone had similar issues?
Secondly, the computer is not allowing me to swith gasses if my air pressure is less than 750psi, which is where I have my alarm set. This is a problem, because it is not uncommon to have just under this amount by the time I am ready to switch over. In the Vytec manual it mentions that it won't allow you to switch gasses if doing so would create a PPO that violates your setting. However, it does not say anything that I can find about not allowing a switch due to the volume in your primary tank.
Anyone had similar issues?