I didn't have time to go through all the directions, just the basics and also to personalize the Vytec. The only problem I felt I had and it's probably only because I'm not too familiar with it was that I dove with my HP100 tank with the Vytec transmitter attached to it, and I dove with a 40 cu ft. pony bottle, staging that. I did not set up the pony bottle on my computer as my 2nd Mix just dove with a Mix 1 setting. Both tanks just had regular 21% air.
Near the end of the dive, I switched from my primary tank to my 40 cu ft. pony for about the last 20 minutes, and when I got out of the water and checked my computer, it did not register the amount of air I consumed for the dive. Is this because I did not stay long enough on my computer that it cut off the readings/recordings?