For Sale SOLD

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

Status
Not open for further replies.

Ken T

Contributor
Messages
265
Reaction score
66
Location
Calgary, AB, Canada
# of dives
50 - 99
$38 USD / $50 CAD plus shipping to your address.


This is the older version of the current "Tec" OMS sidemount adaptor.

Used for a few years on an Oxycheq Backplate Wing setup – both stainless steel backplate and soft travel backplate.

I did have to move the BCD elbow / inflator to the bottom of the bladder and dump valve to the top of the bladder.


Andy Davis at Scuba Tech Philippines has a blog article using the Profile Adaptor Plate to make a sidemount system – “Some options for Homemade / DIY Sidemount Rigs”


Should be adaptable to most backplate wing systems.


It has four bookscrew mounting holes.

Four webbing loops – two at the top, two just above the butt plate.


Three D-rings along each side.

Two rails and two D-rings on the butt plate as well as lash point for crotch strap.


I measure it too be 31 inches long and 14 inches wide at its widest point.


Ideally designed for the OMS Tesseract.


In great condition – no straps were cut, slight scruff and scratch, slight rust marks and
my wife's initials written on the back in yellow.

oms1.jpg oms2.jpg oms3.jpg oms4.jpg oms5.jpg
 
Sold, Thank you.
 
Status
Not open for further replies.
https://www.shearwater.com/products/perdix-ai/

Back
Top Bottom