ScupaPro Mk10+ IP creep

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

Thanks for the links for the SP EBs. Now, because of all you guys, I've jumped in a swell with my 1st SP reg rebuild - an older MK10 without the groove for the spec boot. It has a sharp piston edge, and I managed to get one of the newer gray conical seats. Now, after reading EB 242, I'm not sure if I should change the piston, or will the original piston suffice?

Screenshot2012-07-15at64250AM.jpg
 
That does not apply to your Mk10. It applies to the Mk10+ which used the same cup seat as the Mk20.
 
Oh, good to hear then. So I assume the gray seat will be okay with this and the knife edge piston then?
 

Back
Top Bottom