Scubapro MK 10/ G250 Repair Manual

[ozziworld]

I was wondering if anyone knows of a source for Scubapro Repair Manuals. I was thinking of performing my own maintenance on a MK 10 I recently picked up used.

Are there books or better a dwonloadable repair manual that I can refer to?

Any advise would be much appreciated

 

[Couv]

Hello Ozzieworld,

Welcome to the DIY club. Both service manuals usually discussed here are great. Vance Harlow's "SCUBA Regulator Maintenance …." http://www.airspeedpress.com/newregbook.html and the Peterbuilt Book, "Regulator Savvy" http://www.scubatools.com/ are well worth the money. I own both and recommend getting one of each. If you are dead set on getting only one, then Vance's is a little more suitable for the DIY guy. Peterbuilt has some pretty decent tools too, so if you order from there, pay a few extra bucks and get the bullets, spanners, etc that you need the first time and save on shipping. After just one or two seasons of servicing your own gear, you will have recovered your investment.
​

Here is a website that has tons of regulator specific manuals: Regulator manuals

Good luck,

couv

 

[pescador775]

Frogkick or Scubaengineer might have manuals.
Also:
Scuba Reg., Regulator Service and Maintenance Manuals - eBay (item 160275851351 end time Aug-31-08 10:33:50 PDT)

Regulator Service Manuals - eBay (item 260277815791 end time Aug-31-08 10:43:02 PDT)

Here is some interesting stuff:
http://www.scubaboard.com/forums/regulators/224576-scubapro-mark-10-question.html

http://www.scubaboard.com/forums/regulators/61391-regulator-identification-2.html

http://www.scubainstruments.com/scubapro.html

 

[ozziworld]

Wow! Thanks guys. This is so much more info than I was hoping to get. I did not think about the tools when I originally posted this thread. Now I guess it is obvious I will need the right tools to do the right job. Are some of these tools model specific or are there basically a 'standard set" of tools Regulator Techs use/own?