Scott Hydro Pak+ Scuba Quest BC parts?

[subbie]

Hi,
Does any one have a parts list, parts or source of info for a Scott Hydro Pak full face regulator? I am in the process of trying to purchase one. I last used one in the Navy and have an interest in vintage equipment. I am also looking for a C02 inflation assembly for a Scuba Quest horsecollar BC. It apparently did not come with one as the insertion hole is plugged with a chromed plug. The inflator hose is also lacking the regulator LP adapter, which I have.
Thank you, and safe dives!

 

[ZzzKing]

You might try the Vintage Diving Forum here at Scubaboard. The are also a bunch of old codgers at Vintage Scuba - Vintage Scuba Diving - Vintage Scuba Gear - vintagedoublehose.com.

 

[regulator bj]

Hi,ref. Scott Hydro mask, Historical Diver ran info on the mask in the follwing three mags ie:vol9 issue3 2001 no 29,vol9 issue 4 2001,vol 16 issue3 no56 Skin Diver also covered it Feb 1959 and of course "Basic Scuba" by Fred Roberts hope this infomation will help. regards bj.

 

[regulator bj]

Just seen feb. issue of skin diver on ebay at 60dollars hence posting reprint hope it helps happy new year bj.

 

[Couv]

Hi,
Does any one have a parts list, parts or source of info for a Scott Hydro Pak full face regulator? I am in the process of trying to purchase one. I last used one in the Navy and have an interest in vintage equipment. I am also looking for a C02 inflation assembly for a Scuba Quest horsecollar BC. It apparently did not come with one as the insertion hole is plugged with a chromed plug. The inflator hose is also lacking the regulator LP adapter, which I have.
Thank you, and safe dives!

Hi Subbie, Welcome to Scuba Board.

I cannot help you with the Scott Pack. Tell me about the vest you have with the chrome plug. Is it actually a plug, or is there a stem with a cap on it? When power inflators became popular, lots of folks removed the CO2 firing unit and put a cap over the stem. I’ll look around through my junk file to see if I still have the firing mechanism from one of my old vest, but if I don’t, I’m pretty sure these are the same size as the units on other vest using that set up. If I’m not mistaken, they were made by a company call Robertson.

I suppose you are doing the vintage thing, but if you just want to patch the stem hole, here is a link to a post where you can find instructions on doing that. There are also links within the thread you will find helpful.

Edit: D'oh.....just noticed the OP was made a few months ago.

 

[regulator bj]

Hello Subbie, just a bit more information on the " Scott HYDRO" from the collection. regards bj.