Remote Exhaust valve by Zeagle

[cybdiver]

I did a tune up on my ranger, ordered a bunch of parts etc.
I put the Remote Exhaust valve on can it leaks from the swivel mount.

Yes I put on silicone grease, made sure it was on good and tight. I've taken it apart before to clean it.
This was the first time I've replaced it. The valve on the old one was shot.

Was there supposed to be an O-ring or gasket that came with that? I didn't get one.

Advice or suggestions would be helpful, I'm outside the US so getting even small parts is not that easy a task.

 

[Jeff-F]

Good morning Cyb,

There should be a gray/black gasket (seen in this picture labeled "Flat gasket for... valve") that sits underneath the RE valve which provides the airway seal. Do you still have the old gasket, by chance?

If you have an address of someone here in the USA that you see frequently I'd be happy to send a few of the gaskets to them so that they can forward them along to you.

 

[cybdiver]

The old gasket must have been stuck to the old valve.
I got an email from Mike and he's sending me one.
Thanks......

Good morning Cyb,

There should be a gray/black gasket (seen in this picture labeled "Flat gasket for... valve") that sits underneath the RE valve which provides the airway seal. Do you still have the old gasket, by chance?

If you have an address of someone here in the USA that you see frequently I'd be happy to send a few of the gaskets to them so that they can forward them along to you.

 

[cybdiver]

Replaced the gasket and all is good again, thanks