flyguy
Contributor
I just bought a TransPac II with the Rec Wing and will be diving with a single tank (for now at least). I have little experience with it so please bear with me 
There are 3 grommets where the end of the bungee can be attached to, effectively loosening or tightening the bungee on the inside of the wing. By factory, it was attached to the middle grommet. Would loosening or tightening the bungee have much effect on trim or dumping the air? I don't believe the bungee could to too tight as to prevent the full inflation of the wing using the power inflator. It might require a little more effor if inflated orally.
Also with the weight pockets on the side of the TransPac, would you find it easier with all the weights in the pockets or adding some tank weights to reduce the side weights? I dive with about ~20-22lbs when wearing a full 7mm wet suit in fresh water and 12lbs in warm salt water with a 2mm wet suit.
Thanks in advance for any info.

There are 3 grommets where the end of the bungee can be attached to, effectively loosening or tightening the bungee on the inside of the wing. By factory, it was attached to the middle grommet. Would loosening or tightening the bungee have much effect on trim or dumping the air? I don't believe the bungee could to too tight as to prevent the full inflation of the wing using the power inflator. It might require a little more effor if inflated orally.
Also with the weight pockets on the side of the TransPac, would you find it easier with all the weights in the pockets or adding some tank weights to reduce the side weights? I dive with about ~20-22lbs when wearing a full 7mm wet suit in fresh water and 12lbs in warm salt water with a 2mm wet suit.
Thanks in advance for any info.