Today my Vytec behaved oddly, and I wanted to see if anyone else has had this experiance. My Vytec did not go into dive mode until I was about 10 feet down begining dive. Then it went into dive mode, but started at 0 feet. In other words, it was registering an actual depth of 10 feet as 0 feet. After the dive, while everyone elses computers registered a max depth of 42 feet, mine only registered a max depth of 31 feet. I dove the same profile as everyone else. The only thing I can think of is this: Right before I descended I pressed the "Time" button (bottom right hand side). I'm thinking this may have caused the computer to remain in surface mode for an extra minute, then when I was a 10 feet it went into dive mode and re-calibrated itself to think that this depth was 0 Feet. I'll add that on the next dive, the computer performed fine. Any thoughts? Just hoping there's nothing wrong with the computer.
Question on Vytec
- Thread starter ScubaK-Dawg
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
Similar threads
