One ring system to rule them all (small BARE cuff) - Rolock, PSI, Kubi?

[edgrimley]

Looking for some guidance on wrist seal replacement and dry glove rings.

Have a Bare Tech Trilam suit with aftermarket Rolock 3 cuffs that I installed on the latex seals. Was a huge pain to install. I think the suit-side ring is just a little too big for the suit. When installing I definitely stressed out the wrist seals. After a few years of use, I'm seeing some cracking in the latex and know a replacement is on the horizon. I dread reinstalling that ring and realize it would be a bad idea. That said, love the Rolock system! Once installed, so easy and secure to use.

Options, I think - glue in a permanent suit-side cuff ring or go latex seals with a ring-system to attach. If I go that direction I think I need a smaller ring, which would lead me toward a sized Kubi, Thenar or perhaps a flexible ring system. Hate to move from the Rolock, but alas.

Any thoughts or things I'm missing?

Thanks.

 

[lexvil]

1. Remove the latex seals and glue in si tech QCS suit rings. 2. Buy Rolock 90s and enjoy perfection

 

[Badger7]

1. Remove the latex seals and glue in si tech QCS suit rings. 2. Buy Rolock 90s and enjoy perfection

If I had a suit with a lot of life left in it, but glued latex wrist seals, this is exactly what I would do as well. If it was also getting to the point of needing a new neck seal and a zipper too, I might bail and get a new one with QCS suit rings and a Quick Neck installed factory.

 

[grantmac]

QCS+Rolock 90

 

[edgrimley]

QCS+Rolock 90

Popular recipe.