Ok, here’s the story:
I bought (ordered) a backplate on sale thinking to have a couple separate rigs. I glanced at the plate, thought it looked fine and then packed it away because I was about to move.
Pulled it out recently to install a harness and in the process I discovered some sharp edges and at least one gnarly bur. It’s way too late to return it.
So this is completely on me for not looking it over carefully enough. But maybe someone can help me turn a negative into a positive. Seems like lots of Scubaboard users are handy, DIY types, so I figured it couldn’t hurt to ask.
Anyone with the tools and the know-how willing to round out sharp edges and knock down any burs? I’m in Northampton, MA. Long shot, but get in touch if you want to help and let me know what you’d charge for the service.
Thanks!
I bought (ordered) a backplate on sale thinking to have a couple separate rigs. I glanced at the plate, thought it looked fine and then packed it away because I was about to move.
Pulled it out recently to install a harness and in the process I discovered some sharp edges and at least one gnarly bur. It’s way too late to return it.
So this is completely on me for not looking it over carefully enough. But maybe someone can help me turn a negative into a positive. Seems like lots of Scubaboard users are handy, DIY types, so I figured it couldn’t hurt to ask.
Anyone with the tools and the know-how willing to round out sharp edges and knock down any burs? I’m in Northampton, MA. Long shot, but get in touch if you want to help and let me know what you’d charge for the service.
Thanks!