jqjcn
Registered
- Messages
- 59
- Reaction score
- 2
1 CHAIN CLEARANCE/SLIDER CLEARANCE
The slider and tape must be able to move in their own way during opening and closing. Gluing heavy material too close to the chain will
restrict this action and MAY cause premature failure of the product. It WILL increase the energy required to move the slider.
Slider Action Clearance for Expanded Neoprene
Slider body
1 ZIPPER GLUED INSIDE SUIT
SUIT MATERIAL
2 GLUED OUTSIDE SUIT INTERNAL FLAP TO PREVENT UNDERWEAR ENTERING
ZIPPER ELEMENTS DURING CLOSING.
(Recommended)
3 STITCH AND TAPE-SEAL METHOD
Slider body
SUIT MATERIAL
IF USING TRILAMINATE MATERIAL YOU MAY REDUCE THE CLEARANCES BY 5MM
ZIPPERS GLUED INSIDE THE SUIT MAY ALSO HAVE SEALING TAPE APPLIED FOR EXTRA ADHESION AND SEALING
WHEN WELDING ZIPPERS INTO SUITS YOU SHOULD ALSO FOLLOW THESE INSTRUCTIONS. We recommend you weld with the zipper OPEN.
1 END STOP CLEARANCE
A similar rule applies at the end stops (top and bottom). The chain clearance must continue to the end stop is reached.
The clearance around the block of the endstop should be at least 15mm:
IF IN DOUBT SEEK ADVICE FROM THE NEW ZIPPER COMPANY. PLEASE REVEAL ALL DETAILS OF THE PROJECT (IN CONFIDENCE).
The slider and tape must be able to move in their own way during opening and closing. Gluing heavy material too close to the chain will
restrict this action and MAY cause premature failure of the product. It WILL increase the energy required to move the slider.
Slider Action Clearance for Expanded Neoprene
Slider body
1 ZIPPER GLUED INSIDE SUIT
SUIT MATERIAL
2 GLUED OUTSIDE SUIT INTERNAL FLAP TO PREVENT UNDERWEAR ENTERING
ZIPPER ELEMENTS DURING CLOSING.
(Recommended)
3 STITCH AND TAPE-SEAL METHOD
Slider body
SUIT MATERIAL
IF USING TRILAMINATE MATERIAL YOU MAY REDUCE THE CLEARANCES BY 5MM
ZIPPERS GLUED INSIDE THE SUIT MAY ALSO HAVE SEALING TAPE APPLIED FOR EXTRA ADHESION AND SEALING
WHEN WELDING ZIPPERS INTO SUITS YOU SHOULD ALSO FOLLOW THESE INSTRUCTIONS. We recommend you weld with the zipper OPEN.
1 END STOP CLEARANCE
A similar rule applies at the end stops (top and bottom). The chain clearance must continue to the end stop is reached.
The clearance around the block of the endstop should be at least 15mm:
IF IN DOUBT SEEK ADVICE FROM THE NEW ZIPPER COMPANY. PLEASE REVEAL ALL DETAILS OF THE PROJECT (IN CONFIDENCE).