BarryTX
Contributor
Hi,
I'm getting ready to take this G11 / YS-110a / Fisheye FIX case setup into the ocean for the first time. I wanted to double-check thoughts on best settings - I'll mostly be diving a reef & would like some good shots of marine life there. I'll be shooting through a Fisheye FIX housing with the standard port, no wide angle attached, and a strobe mask to block out the G11's own flash. The strobe is attached with a fiber optic cable
I was thinking I would set the camera in Aperture mode, flash set to always on. Is this the best appoach?
I've seen some recommendations that the G11's flash should be dialed down as much as possible - is this correct?
On the YS-110a, I plan to set to Manual 1, Slave On, Power Full. Is these the right settings for the strobe to read the preflash and adjust the strobe's flash power accordingly, or is there a better way?
Any comments will be appreciated!
I'm getting ready to take this G11 / YS-110a / Fisheye FIX case setup into the ocean for the first time. I wanted to double-check thoughts on best settings - I'll mostly be diving a reef & would like some good shots of marine life there. I'll be shooting through a Fisheye FIX housing with the standard port, no wide angle attached, and a strobe mask to block out the G11's own flash. The strobe is attached with a fiber optic cable
I was thinking I would set the camera in Aperture mode, flash set to always on. Is this the best appoach?
I've seen some recommendations that the G11's flash should be dialed down as much as possible - is this correct?
On the YS-110a, I plan to set to Manual 1, Slave On, Power Full. Is these the right settings for the strobe to read the preflash and adjust the strobe's flash power accordingly, or is there a better way?
Any comments will be appreciated!