Eric Sedletzky
Contributor
I have a few one off prototype odd and end Freedom PLates in the shop that I want sell. Their not doing anybody any good sitting on a shelf, right?
I have three different versions of Plates listed below.
The first is a 3/16" aluminum plate 14 1/2" tall and 9.5" wide. It is polished and weighs 1Lb. 4oz. This is the lightest plate made.
The second is also a 3/16" aluminum plate, same height but it is 12" wide at the base. It also has a nice polish. It weighs 1lb. 8 oz.
The third plate is a stainless version that is very narrow at the base and has a rail on the back. The rail was an older version and was too labor intensive to produce so I discontinued it. The design is still valid however. This plate is only 7 3/8" wide at the base and 14 1/4" tall. It has a brushed finish. This model tended to be a little unstable with larger tanks because it is so narrow at the base, but with smaller tanks and a crotch strap it should be fine. This plate is probably the most unique of any I've made and would be perfect with a PRAM because of the rail. It would give the reg can room. This plate weighs 2 lb. 10 oz.
All three of these plates are designed around the Oxycheq Mach V series wings. Other wings may work but I don't know for sure because Oxycheq single tank wings are all I've ever used.
The plates are $100 each plus shipping.
I take visa or M/C. Sorry, I'm not set up to take Paypal.
PLease e-mail me at ericsedletzky at yahoo dot com
or call me at:
(707) 318-2577 cell
(707) 538-1276 office
The first two pics are the narrow stainless plate
The third photo is the 9.5" aluminum plate. I don't have a pic of the wider aluminum plate but it looks similar to the third photo but just a bit wider at the base.
I have three different versions of Plates listed below.
The first is a 3/16" aluminum plate 14 1/2" tall and 9.5" wide. It is polished and weighs 1Lb. 4oz. This is the lightest plate made.
The second is also a 3/16" aluminum plate, same height but it is 12" wide at the base. It also has a nice polish. It weighs 1lb. 8 oz.
The third plate is a stainless version that is very narrow at the base and has a rail on the back. The rail was an older version and was too labor intensive to produce so I discontinued it. The design is still valid however. This plate is only 7 3/8" wide at the base and 14 1/4" tall. It has a brushed finish. This model tended to be a little unstable with larger tanks because it is so narrow at the base, but with smaller tanks and a crotch strap it should be fine. This plate is probably the most unique of any I've made and would be perfect with a PRAM because of the rail. It would give the reg can room. This plate weighs 2 lb. 10 oz.
All three of these plates are designed around the Oxycheq Mach V series wings. Other wings may work but I don't know for sure because Oxycheq single tank wings are all I've ever used.
The plates are $100 each plus shipping.
I take visa or M/C. Sorry, I'm not set up to take Paypal.
PLease e-mail me at ericsedletzky at yahoo dot com
or call me at:
(707) 318-2577 cell
(707) 538-1276 office
The first two pics are the narrow stainless plate
The third photo is the 9.5" aluminum plate. I don't have a pic of the wider aluminum plate but it looks similar to the third photo but just a bit wider at the base.
