boboxx
New
Here is my DIY strobe arm and tray...
I used some 1/2" loc-line, 1/2" grey PVC pipe, some lexan (polycarbonate), a aluminum tent peg, a small sheet of 1/4" ABS and a old commercial aluminum door handle. Total cost was about 18$
I have attached the images as I cant post URL
Thanks
I used some 1/2" loc-line, 1/2" grey PVC pipe, some lexan (polycarbonate), a aluminum tent peg, a small sheet of 1/4" ABS and a old commercial aluminum door handle. Total cost was about 18$
I have attached the images as I cant post URL
Thanks
Attachments
-
5289_1033547139395_1846937226_69591_7395257_n.jpg25 KB · Views: 136
-
5289_1033547179396_1846937226_69592_5163216_n.jpg31.5 KB · Views: 119
-
5289_1033547219397_1846937226_69593_5652726_n.jpg19.5 KB · Views: 130
-
5289_1033547259398_1846937226_69594_5767721_n.jpg38.5 KB · Views: 114
-
5289_1033547299399_1846937226_69595_2953831_n.jpg33.9 KB · Views: 112
-
5289_1033547339400_1846937226_69596_793808_n.jpg37 KB · Views: 121
-
5289_1033547379401_1846937226_69597_2596085_n.jpg40.9 KB · Views: 120
-
5289_1039640731731_1846937226_84542_2613297_n.jpg71.3 KB · Views: 107
-
5289_1039640771732_1846937226_84543_6751718_n.jpg53.3 KB · Views: 139
-
5289_1039640811733_1846937226_84544_7167857_n.jpg50.7 KB · Views: 145