dip tubs

[nitrox30]

Can any one tell me where I can find a replacement dip tube brass or steel for an old US divers tank valve. The orginal one was plastic and must be replaced?

 

[Afraid_of_Fish]

Welcome to Scuba Board!! Sorry, can't help you there, but I'm sure there are people here who both can, that are more than willing, to help you. If you have any questions feel free to PM me. See you around the board!!

<33 Jess

 

[Scott Riemer]

Welcome. You may want to post your question here:
Tanks, valves, and bands forum

 

[SDAnderson]

Your local dive shop should have them.

You've got an ancient valve that seemingly hasn't been maintained and new valves are reasonably cheap. If you haven't had your valve serviced recently (cleaned, o-rings, washers and seats replaced, etc.), for the cost of an overhaul and replacement dip tube you might be paying for most of a new one.

 

[DandyDon]

Howdy!

Welcome to SB!! :happywave Put us in your computer's favorites and check in often. This is a great place to learn, compare, argue Look around our various forums - everything from New-To-Scuba to Instructors-Only to Dive Medicine.

don

 

[baitedstorm]

Heya and welcome to the Board! This a great place to hang out during a SI. You’ll meet tons of new friends and dive buddies right here! This place has a wealth of knowledge to offer divers of any level.
Best wishes !

 

[headhunter]

Welcome to ScubaBoard! :happywave

It sounds like you're already getting answers to your question. The question is beyond my level of knowledge, but I still wanted to welcome you to our board.

Dive safe!

Christian

P.S. Due to the high volume of new posts in the Introductions and Greets forum, it's not always possible to keep up with all the new posts here. So, please help me out and send me a PM if you post anything you want me to read or repsond to in this forum.
almtree: :sunny

 

[sharkdiver00]

Welcome to the board! Try your local dive shop, they should be able to get you one, but if you have not had it maintained, the cost of clean and overhaul will be very similar to buying an entire new one.

Try posting your question on the 'tanks & valves' forum anyway.

Maria

 

[Matt the Aquaman]

Can any one tell me where I can find a replacement dip tube brass or steel for an old US divers tank valve. The orginal one was plastic and must be replaced?

Hello from Matt,

Welcome to ScubaBoard ! :1poke: I came here to look for help with my scuba diving dream and the response has been fantastic. So, I know you will enjoy being a member here.
There are a lot of nice and informative scuba divers. It's a good place to meet other divers and share experiences and dreams. Take care from Matt.

 

[nitrox30]

Welcome to the board! Try your local dive shop, they should be able to get you one, but if you have not had it maintained, the cost of clean and overhaul will be very similar to buying an entire new one.

Try posting your question on the 'tanks & valves' forum anyway.

Maria

I have tryed all the dive shops none have it the valve is allmost new ( not ever used) It is a standard corse thred so I should be able to find one sooner or later
Thanks Nitrox30