Whilst setting up for a dive tomorrow I broke one of the pins that the strobe cord plugfits on. Is this a back to Inon jobbie?
Damaged Inon
- Thread starter aquakiwi
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
bvanant
Contributor
Unfortunately I think yes since getting the parts is going to be very tough.
Bill
Bill
Reef Photo
Registered
New sync plugs should be available from any Inon service center. We have them in stock here. The problem is changing it out is cumbersome and labor intensive, requiring most of the strobe to be disassembled. If you feel like sending it across the world to us, we can help you with it.
However, it might not be necessary to replace it. Most likely you're shooting manual? If so, is the broken pin either the trigger or ground? If not, jut keep using it as-is.
However, it might not be necessary to replace it. Most likely you're shooting manual? If so, is the broken pin either the trigger or ground? If not, jut keep using it as-is.
OP
I think the pin is either the trigger or ground, I'm looking at a dealer in Australia, otherwise Florida here it comes.
Similar threads
