Just got a new BC and it came with a flexible inflator hose. I'd like to use it, is there anything specific I need to do to replace the existing one? Is it easy to do or should I take it to the diveshop and let them do it.
The manual says "Check to ensure the o-ring is present and in good condition.
Screw the threaded end of the hose into the port and tighten to
40 in-lbs (4.5 Nm) with a 9/16 wrench."
So does that mean all I need is to find a 9/16 wrench and I should be able to remove the old one and then put the new one on? How do I know what 40 in-lbs is equal too when I tighten it?
The manual says "Check to ensure the o-ring is present and in good condition.
Screw the threaded end of the hose into the port and tighten to
40 in-lbs (4.5 Nm) with a 9/16 wrench."
So does that mean all I need is to find a 9/16 wrench and I should be able to remove the old one and then put the new one on? How do I know what 40 in-lbs is equal too when I tighten it?