I hooked up my original zoop to my Mac with the suunto software. After disconnecting it, the time would work but when I pressed the mode button it thinks I am on a dive I am locked out from pressing any buttons. I cannot hook it back up to my computer as I need to hit the PC mode.
I took the battery out for a few hours and I am still having the same problem.
I even took the watch when it was on time mode after replacing the battery and put it in the pool to see if it would read again. It activated and was still in a Dive mode which would not shut off. It also was not accurate at all.
I know there is no way to clear the zoop, but any ideas on how to restore it back to factory standards?
I took the battery out for a few hours and I am still having the same problem.
I even took the watch when it was on time mode after replacing the battery and put it in the pool to see if it would read again. It activated and was still in a Dive mode which would not shut off. It also was not accurate at all.
I know there is no way to clear the zoop, but any ideas on how to restore it back to factory standards?