What a revoltin' development!
I just finished a shallow dive this morning and wanted to pull the data from my Aeris Atmos 2. I had a devil of a time getting the laptop and the atmos talking to each other, but nothing I haven't seen before.
I finally got them talking after lots of cable wigglin', but then the laptopn SW said the dive data was invalid. I *think* that the 120 sec download mode countdown expired in the middle of the download. More importantly, this left the Atmos in what looked like "download mode", with all LCS segments displayed.
No button pressing of any kind could exit this mode.
However, after a few minutes, the Atmos reverted to what looked like normal surface mode.
When I tried the download again, this time I got "handshake failed" on the computer, and the Atmos seems stuck in some kind of loop.
I get "CAL" blinking, then "CSM" blinking, followed by all segments (with backlight), then the normal startup countdown (no backlight) and then back to CAL again.
It's been about 15 minutes and it still looks stuck.
Shouldn't be a battery issue as the Atmos is less than 3 months old, and has only 9 dives on it. The battery indicator was indicating full charge before and after the dive.
Any suggestions? If this has to go back to Aeris I'll have to admit to being quite unhappy :-(
I just finished a shallow dive this morning and wanted to pull the data from my Aeris Atmos 2. I had a devil of a time getting the laptop and the atmos talking to each other, but nothing I haven't seen before.
I finally got them talking after lots of cable wigglin', but then the laptopn SW said the dive data was invalid. I *think* that the 120 sec download mode countdown expired in the middle of the download. More importantly, this left the Atmos in what looked like "download mode", with all LCS segments displayed.
No button pressing of any kind could exit this mode.
However, after a few minutes, the Atmos reverted to what looked like normal surface mode.
When I tried the download again, this time I got "handshake failed" on the computer, and the Atmos seems stuck in some kind of loop.
I get "CAL" blinking, then "CSM" blinking, followed by all segments (with backlight), then the normal startup countdown (no backlight) and then back to CAL again.
It's been about 15 minutes and it still looks stuck.
Shouldn't be a battery issue as the Atmos is less than 3 months old, and has only 9 dives on it. The battery indicator was indicating full charge before and after the dive.
Any suggestions? If this has to go back to Aeris I'll have to admit to being quite unhappy :-(