failure

I want to hear stories of reliability or failure/malfunction specific to Divesoft Liberty CCRs. I’d prefer first hand accounts but stories about a friend who dives the unit will also work. Please keep posts specific to DiveSoft Liberty unit configurations: (Backmount, Sidemount, Light, Heavy)...

Hi all, I am having issues with my Sea&Sea YS-D2 strobe as it is not firing and the ready light is continually flashing. I’ve tried multiple sets of batteries to no avail so hopefully someone has some ideas. In my troubleshooting I've managed to turn on and off the internal protective circuit...

I can't seem to find any info on the subject for analyzers, most are recommendation for rebreathers. I am doing a project on an Arduino based O2 analyzer. I would like to know if there is a cutoff voltage value (in air) for the sensor to be considered "bad" and lose its linearity significantly...

Hello, I am a relatively inexperienced PADI open water certified diver. I'm sure we probably covered this in the course but I wanted to make sure I had the right solution to the issue I experienced. I shore-dived in Oslob, Phillipines with rented gear and the sea was only about 20 meters...

So I was doing my ritualistic pre-dive checks and noticed my OPV was leaking. When I checked to ensure it was screwed on tight the whole thing basically separated from the BC. It seems that the pioneer is a one-piece shell and does not have an internal separate bladder. Is this something that...

Not even in the water. Turn it on, it does a little buzz, and the power indicator light comes on.... and then that's it. No chime, no display screen. It doesn't respond to any input, and the only way to make the power indicator light go off is to remove the battery. Memory card is fine ( I can...

I don't know it this is allowed. But I'm having issues regarding software upgrades on the Galileo Luna. I'm trying to do the following sequence of upgrades: SW 1.5 --> SW 1.6/ 2.1 SW 1.6/ 2.1 --> PMG PMG --> Trimix I have a fully functional irda dongle (extracting dives and uploading settings...

I'm a very new diver - this incident occurred on dive 8 for me. We were diving the Clackamas river, a relatively small river just outside of Portland Oregon. The current is quite strong, but at Big Eddy there's a swirling current where the river hits a large rock that creates a pocket of...

I'm heading out for a weekend of camping and diving one of our local lakes. To save time, my boyfriend offered to pick up my tanks while I was at work yesterday. I called the shop and confirmed everything over the phone. He was able to pick them up and everything seemed all good. He transferred...

I hope this information is useful to someone. 25 dives after a complete rebuild service for my Aqualung Legend LX I had my first stage fail shut at 60 feet 40 minutes into the dive. Fortunately my buddy recognized the international signal for out of air - eyes as wide as saucers - and he had...