OMS COMFORT HARNESS AND 2.0 WING

[Calabash Digger]

My first look video at this backplate and wing...

 

[BoltSnap]

Questions:

1. Why longer inflator hose?

2. Why Inflator hose with hump valve?

3. Can't they make a bigger harness for you? Push them to make you one instead of returning it.

 

[Calabash Digger]

It is what I prefer on the dump ...Try dropping rapidly into 30 ft of high current dark water holding lights and a metal detector...dump valve makes my life WAY easier. Longer hose is because I am so big in the chest and a 16 inch hose rides to high and does not give me enough movement if I need my second air source... It will work but the 19 inch is way better. Harness was all the way out...Dropped off at post office already..

 

[lexvil]

All you need todo is change the two lower pieces of the shoulder harness to make it work for you, while I’m not as big as you I’m not that off, I use the lower “T” bars sort of set up too, I put Zeagle weight pockets between the plate and the “T”. It looks way to close to want you want to send it back when $10 worth of webbing will solve this issue .

 

[Calabash Digger]

Dang sent back already....Tell me what I should have done to correct it? Thanks! I was thinking I would have to redo the whole harness setup..

 

[BoltSnap]

Dang sent back already....Tell me what I should have done to correct it? Thanks! I was thinking I would have to redo the whole harness setup..

You should check with us here first before your return anything, we're your friend and will help you to find solutions for you

Did you check the new Scubapro BP/W system? They have adjustable should straps, weight system, etc.

 

[lexvil]

Dang sent back already....Tell me what I should have done to correct it? Thanks! I was thinking I would have to redo the whole harness setup..

With the “T” bar (the part you moved forward on the waste belt) the short piece of webbing between that part and the bottom of the shoulder buckle (the part you like made of metal) is all you needed to change, one on each side.

 

[Calabash Digger]

You should check with us here first before your return anything, we're your friend and will help you to find solutions for you

Did you check the new Scubapro BP/W system? They have adjustable should straps, weight system, etc.

Thanks! I have not but will look at it..What gear of theirs I have looked at in the past ran small for me..

 

[Calabash Digger]

With the “T” bar (the part you moved forward on the waste belt) the short piece of webbing between that part and the bottom of the shoulder buckle (the part you like made of metal) is all you needed to change, one on each side.

Dang , That would have made it perfect...Can you buy a kit to stitch the webbing closed around the buckle?

 

[lexvil]

Dang , That would have made it perfect...Can you buy a kit to stitch the webbing closed around the buckle?

Can’t say since I don’t stitch them and haven’t seen how that buckle is attached, I just make a loop at each end of that pice of strap with triglides.