Jardine
Registered
Has anyone found any DIY parts or methods for replacing the HP seats in the Scubapro Mk11 and Mk17 diaphragm 1st stages? I've been doing lots of searches in this forum and there's not much posted about these two regs.
So if you're going to hold off on spending the money for a parts kit for these two, would you just check these every so often and see if you get any IP creep after cycling the first stage a bunch of times? I've read that the seats in these can last many years. So if I clean, inspect, and replace o-rings every year, is IP creep the first indication that I will detect that it's time to replace the HP seat?
Thanks,
Bruce
So if you're going to hold off on spending the money for a parts kit for these two, would you just check these every so often and see if you get any IP creep after cycling the first stage a bunch of times? I've read that the seats in these can last many years. So if I clean, inspect, and replace o-rings every year, is IP creep the first indication that I will detect that it's time to replace the HP seat?
Thanks,
Bruce