WhiteSands
Contributor
- Messages
- 668
- Reaction score
- 79
- # of dives
- 200 - 499
I recently purchased an inline adjusting tool, and the hex bit on the tool measures 5mm.
I understand this is the standard size for most 2nd stages out there.
However the adjusting screw on my HOG Classic 2nd stages are 4mm.
How do techs deal with this problem? The bits on my adjusting tool does not seem to be swappable.
I understand this is the standard size for most 2nd stages out there.
However the adjusting screw on my HOG Classic 2nd stages are 4mm.
How do techs deal with this problem? The bits on my adjusting tool does not seem to be swappable.