Kiss Orca Spirit LTE/Sidewinder O-ring sizes

[Gone for diving]

The big ones in particular are very hard to measure precisely

Don't try to measure the oring other than thickness....
measure the housing, or the bore.
You can use a tape measure across the bore. With care you can do quite accurate work.
Standard orings can be measured by inside or outside diameter... figure out the thickness, then the ID or the OD. Look on an oring chart, an get the dash#

Tip for standard orings, for instance a 1/8 oring will measure (new) a bit over .125"....
Like aprox ..136" the oring compression is built into the oring, unlike metric orings. Which can be a real pain.

 

[happy-diver]

If it is online and unclear or your orings are mashed you buy maybe sizes above and below as well

At the oring shop the guy throws what he thinks are the right sizes on the counter and you choose

And remember to place them on a white sheet of paper, as the sizes then jump out at you like jack

 

[Viperz28]

Has anyone tried these kits?

O-Rings

 

[InWay2Deep]

Did you ever complete this list? If so could you share?

Thanks

 

[hroark2112]

This is what I got from Kiss

Spirit Orings
4- 240 head
4- 45 x 3 base
2- 28 tower
2- 224 counterlung
8- 127 hose QD (4 for Hollis BOV)
1- 112 Valve body
2- 128 Hollis BOV
1- 220 OPV

 

[J-Vo]

Interesting, they have refused to give these to me.

 

[davehicks]

Kiss will sell a full set of o-rings at a reasonable cost. It's nice to be able to source spares independently but kind of a pain.

 

[hroark2112]

Kiss will sell a full set of o-rings at a reasonable cost. It's nice to be able to source spares independently but kind of a pain.

Luckily for me we have a rubber hose and gasket company locally that stocks lots of o-rings.