Uwatec smart pro battery

[lagerstjerne]

Hi a friend of mine gave me an Uwatec smart pro, that needed a new battery.
Replaced it, but now it shows a small spanner on the display, nothing else.
Will it need new firmware or some sort of reset? Can only find info about Alladin on the net, but somebody must have been in the same situation before.
On the center of the print is an infrared eye, believe it is for service, but how and type of program??

 

[rollorcs]

Hello,

same problem here, anybody knows how to reset the smart Pro after battery change??

Seriell Interface does not work as on earlier models.

???

kind regards

 

[viterda]

any suggestion? i have the same problem.
thanks
Vi3da

 

[hallbigdaddy]

You guys get an answer, mine died after replacement too...

 

[tech3324]

I don't know specifically about this computer, but try removing the battery, short the computer's battery terminals together for a few seconds, and replace the battery into the computer. This can serve to reset computers that have a keep-alive capacitor in them.

 

[viterda]

i tried your suggestion but it still doesn't work. i don't see any "pad" on the motherboard to HW reset the ucontroller. i also think it cannot a so complicated procedure, but i hope it doesn't need some interaction with the IR interface...

 

[Dunco]

Hi everybody. I know how reset uwatec smart com. I had same problem. But today I was reset my console and it works.

But if you want know how, please somebody send my photo of electronic board of Uwatec Smart Com. Here is my email michal@danc.sk

Sorry for my english.

 

[Dunco]

Hi all.

Some guys tried reset thier SmartComs with by my manual and all is OK. So I now know that is good way. If somebody will want this manual write me.

michal@danc.sk

 

[matsat64]

will this work with the smart Z?

 

[Dunco]

I really dont know.

Check it. Here is my manual

http://www.evva-martin.sk/fotky832/scuba/RESET-UWATEC-SMART-COM.pdf

Dunco