Source for BC replacement gaskets?

[bill_bain]

The flat gaskets that seal the inflator elbow adn teh rear dump valves on a couple of my BCs have gotten hard and creased from being place for some time. Is there a common source for these types of new gaskets? If it matters, the BCs in question are a Sherwood and two Seatecs. Also the flat gaskets in an old SeaQuest wing power inflator need to be replaced as well.

 

[Packhorse]

Any place that sells epmd or neoprene. Buy a roll and make hundreds! In NZ we have Para rubber that sells it.

 

[mksmith713]

Ditto on the "Make them yourself".
I went through the same thing you're going through.
I ended up using bicycle inner tube to make gaskets for my daughters BC dump valve.
A year later they still work fine

 

[herman]

You can sometimes get large rubber washers at home improvement stores.