Sherwood G250 and MK20 Ultralight

[Erich in Az]

Just getting back in to scuba, and wanted to see if you folks think a Sherwood G250/MK20 Ultralight combo would be worth $100 or so. Are parts available and can they still be serviced?

I'm going to take a 2nd look at some used equipment. They also have an XLP/XL combo for about the same price, but they seem tougher to find parts for and probably a bit older.

I think I read that the MK20 had a recall. Did that affect the ultralights also?

Thanks

 

[wwunder]

That would be scubapro not sherwood and if its in decent condition $100 is a steal. I'm not up on all the recalls, but it should be easy enough to look up.

 

[zider]

I agree, that is a good price on those. The G250 could be sold for 100 on its own. Be sure to have both regs serviced by a Scubapro shop prior to use. If the MK20 has not been corrected for the recall, the shop will do it for free.

 

[Erich in Az]

Seriously...

 

[Erich in Az]

I need...

 

[Erich in Az]

2 more posts...

 

[Erich in Az]

Before I can post the pics...

 

[Erich in Az]

... and I'm spent...

Yeah, it was Scubapro, not Sherwood. I don't know why that stuck in my head. In any case, here is the haul (please excuse the dismal photos from my cell phone)...

G250/MK20 Ultra light, Scubapro Eclipse snorkel and an Atomic mask - $114 out the door for all of it

2nd stage. Has some scuffs, but no big deal. It holds vacuum when I inhale and the 1st stage is capped, and exhales normally so the diaphram is not too jacked up.

1st stage. What's the dealio with the Ultra light designation?

I guess this is the serial #

What connector is this?

I think this one is for an Air II. They had a BC there with an Air II on it and it seemed to plug in. I'm not sure if I want an integrated one or a regular octo. I think I can get the BC (I think it was a kniighthawk, but it's too small for me) for about $100

I need some sort of oct, and a console and I'm in happy land! Then I'm off to find a BC and fins


Now I just need to find a wet place here in the middle of the desert. :sigh:

 

[Couv]

Yes, just the 250 is worth the 100 bucks just by itself....well done on that deal.

The connector you ask about, is that on the end of a high pressure hose? At any rate, it looks like whatever it was removed from it was done improperly. I think that is either part of the assembly if was removed from and/or the jam nut that holds it in place.

Couv

 

[Erich in Az]

I think it is on a high pressure port. It almost looks like some sort of quick release fitting, but I'm not sure.