SCUBA Pro MK25/S600 Regulator

[jonscubas]

I have experience with both the Apeks ATX200 and the SCUBA Pro MK25/S600, and both are great. You have to admit though if you are world traveling diver, my understanding is that it is easier to obtain SCUBA Pro repair parts then Apeks. My LDS won't sell me replacement parts for my SCUBA PRO, would be nice to have extra parts as backup.

I've been researching though and you kind of need some expensive tools and gauges to properly configure your regs for optimum breathing at depth.

I have not been able to find an Schematic for the MK25/S600 anywhere. Anybody know where to get one? Better yet where to obtain parts and a repair manual?

 

[redacted]

But if you must:

I told you a place to go for parts.

tools: www.scubatools.com

knowledge: www.airspeedpress.com

I recommend that you start with the book from Vance Harlow and go from there. If you take good care of that regulator, you shouldn't have to do anything to it for a couple years. That should give you enough time to assemble what you will need. Folks on this board and other similar boards may also help.