Review Самостоятельное изготовление DPV буксировщика дайвера

[grantmac]

Your scooter is running a little quieter, it would be interesting to know what the speed is on the propeller. I had a camera mounted on the body above the engine, so all the vibrations are felt stronger and the speed on the propeller is approximately 2800. If your scooter has a manual, read it

Not listed in the manual but I doubt it's above 1000rpm. I should get an optical tach and check for fun sometime.

 

[Михаил]

Not listed in the manual but I doubt it's above 1000rpm. I should get an optical tach and check for fun sometime.

It would be interesting to know the shaft speed

 

[Михаил]

Hello everyone, there was a need to assemble the battery for the DiveX Sierra scooter, the old metal hydride batteries no longer work, so I decided to assemble it with LiIon, I decided to do the assembly at 25.2 volts, so as not to burn out the controller, since there is information that the controller can be used at 29.4v burn out, that’s why this assembly, if it shows itself well, I’ll assemble it at 29.4v.

 

[Михаил]

Hello everyone, there was a need to assemble the battery for the DiveX Sierra scooter, the old metal hydride batteries no longer work, so I decided to assemble it with LiIon, I decided to do the assembly at 25.2 volts, so as not to burn out the controller, since there is information that the controller can be used at 29.4v burn out, that’s why this assembly, if it shows itself well, I’ll assemble it at 29.4v.Немного фото, сборка еще не закончена предстоит загерметизировать батарею.

 

[Михаил]

 

[Михаил]

 

[The Chairman]

Looks great!

 

[happy-diver]

Well you certainly made sure the spot welds will keep on keeping on

 

[Михаил]

Well you certainly made sure the spot welds will keep on keeping on

Of course, it was welded securely, on both sides according to the diagram, then there is a photo of welding on both sides

 

[Михаил]

Continued welding of contacts