PT015 Rebuild

[jwlast]

Howdy

I've got a PT-015 housing I've been using for the last year and a half (about 140 dives total). Noticed some of the button have small grains of sand embedded by the o-rings, on/off switch is starting to tighten up, etc. Just the minor problems that go along with extended use.

Question is, is there a rebuild kit for these (ie new o-ring seals for the buttons, etc) or does anybody offer this service? I've since bought a new PT-015 case (after a long search on the internet I finally found 1...just 1), just exploring the possiblities of rebuilding and possibly selling.

Thanks

JT

 

[jcclink]

PT-015 O-Ring Sizes

Here's a URL to the thread that contains all the information on the c5050 orings:

http://www.digitaldiver.net/yabbse/index.php?board=2;action=display;threadid=5433

Japanese JIS 2401 "P" series is the Standard for sizes P3 & P5, you'll find the standard here: http://mdmetric.com/or/jispgb.htm

All o-rings BUNA 70 (aka nitrile)

buttons:

seventeen o-rings, order number OR-2.8X1.9 from Maryland Metrics ( $3.94 per 100)
(aka Japanese Standard Size P3) http://mdmetric.com/

on/off & mode dial control:

one o-ring, order number OR-4.8X1.9 from Maryland Metrics ( $3.94 per 100)
(aka Japanese Standard Size P5)

one o-ring, Precision Associates custom o-ring 0.053 x 0.074 (unknown cost)
http://www.precisionassoc.com/customf.htm (1-800-394-6590)

 

[f3nikon]

Don't forget the silicon grease for the o-rings, needed for dynamic sealing applications.