buckybwhiplash
Registered
I recently purchased a used Scubapro Knighthawk BC thats in great shape but it has an integrated Air2 octo/inflator attached to the hose. I really dont care much for the Air2 and since I already have a decent AquaLung Legend octo on my reg set, I would rather switch it out with a simple power inflator.
I went to the local dive shop to check on getting the standard Scubapro version but the list price was almost $100. That seemed pretty high for what the item actually does so I though I would check to see if anyone here has changed one out for the power inflator you see on most backplate/wing setups. I pulled the hose back and measured the OD of the hose connection of the Air2 and its 1 excluding the small barb.
If anyone here has performed this mod or happens to know the hose connection OD of your typical OMS, DSS, OxyCheq, DiveRite, etc. power inflator, I would greatly appreciate it.
I went to the local dive shop to check on getting the standard Scubapro version but the list price was almost $100. That seemed pretty high for what the item actually does so I though I would check to see if anyone here has changed one out for the power inflator you see on most backplate/wing setups. I pulled the hose back and measured the OD of the hose connection of the Air2 and its 1 excluding the small barb.
If anyone here has performed this mod or happens to know the hose connection OD of your typical OMS, DSS, OxyCheq, DiveRite, etc. power inflator, I would greatly appreciate it.
