reefvagabond
Contributor
Ok, so this may seem like a silly question, but is there a way to prevent the RG1208-5 regulator's turrent from spinning?
Possible to stop 1st stage reg turret from moving?
- Thread starter reefvagabond
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
What is the problem you are trying to address ie why do you want to stop the turret being a turret? What's your gear setup? Photo?
The short answer is probably No, but if you position your LP hoses on the turret in the right places it might have the desired effect
The short answer is probably No, but if you position your LP hoses on the turret in the right places it might have the desired effect
- Messages
- 20,692
- Reaction score
- 15,275
- # of dives
- I'm a Fish!
depends how far you want it to spin. You can wrench the turret bolt down hard enough it will be hard to spin. You can also try putting a less slippery gasket in there to prevent it from slipping *both of these are NOT recommended*
If you're diving singles I know it's a pain to have the turret, but you can get a longer LPI hose and you can use that to adjust where the turret sits. It's a PITA but you don't have a whole lot of options at this point
If you're diving singles I know it's a pain to have the turret, but you can get a longer LPI hose and you can use that to adjust where the turret sits. It's a PITA but you don't have a whole lot of options at this point
WetBoy101
Contributor
Or some Duct Tape!!
Similar threads
