elgoog
Contributor
Hello -
I had a slight leak in my left post yesterday and narrowed it down to the 1st stage. The screw in DIN insert was slightly loose. When I removed it completely to check on it, I noticed that the o-ring just above the inside threads was extruded due to the reg being pressurized with the insert not fully tightened down.
Could you let me know what o-ring size I should get to replace this one? This is not the normal DIN o-ring on the outside of the 1st stage - the one I'm asking about is not visible when the reg is in dive ready state.
I've attached a photo of the part I'm referring to.
Thanks in advance,
elgoog
I had a slight leak in my left post yesterday and narrowed it down to the 1st stage. The screw in DIN insert was slightly loose. When I removed it completely to check on it, I noticed that the o-ring just above the inside threads was extruded due to the reg being pressurized with the insert not fully tightened down.
Could you let me know what o-ring size I should get to replace this one? This is not the normal DIN o-ring on the outside of the 1st stage - the one I'm asking about is not visible when the reg is in dive ready state.
I've attached a photo of the part I'm referring to.
Thanks in advance,
elgoog