JDelage
Contributor
All,
I have a NA-RX100II housing on a flexitray II + handle and one Inon Z-240 strobe on each handle at the end of (5"+8+) arm assembly. Today I took my rig in the pool to familiarize myself with it, and found that the right handle was getting loose over time. Has anyone else experienced this? It's possible I didn't tighten the screws enough. On the other hand, I need the handle as far away from the housing as possible to manipulate the buttons, and the handle is just held by those two small screws, so I'm worried.
Thanks,
JD
I have a NA-RX100II housing on a flexitray II + handle and one Inon Z-240 strobe on each handle at the end of (5"+8+) arm assembly. Today I took my rig in the pool to familiarize myself with it, and found that the right handle was getting loose over time. Has anyone else experienced this? It's possible I didn't tighten the screws enough. On the other hand, I need the handle as far away from the housing as possible to manipulate the buttons, and the handle is just held by those two small screws, so I'm worried.
Thanks,
JD