Light Monkey 21W HID canister lid ballast question

[vioch]

Which wire inside the canister lid should go to the plus - red (which is going through the switch) or black (directly from the ballast module)? Just disassembled canister lid for sealing gland replacement and now need to assemble it back =)))

 

[lucca brassi]

normaly red ;-)

point is that with disconnected red , electronics parts could with the time discharge itself ( condensators , HV coil.....) smoothley.

In opposite way with red on and black off , electronics parts might stay on tension longer time and may couse somtimes problems .

 

[vioch]

Done! But light doesn't want to switch on

---------- Post Merged on September 12th, 2012 at 10:37 PM ---------- Previous Post was on September 11th, 2012 at 02:47 PM ----------

LM confirms red wire. So need to check HID bulb...