Forensics Detectors CO Meter

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

MtnDiverColorado

Contributor
Messages
237
Reaction score
371
Location
Colorado
# of dives
100 - 199
Does anyone have any experience with this CO detector for Scuba?


I had thought the Palm was the one to get, but then came across this, and was intrigued, especially as it is a lot less expensive. However, I am also concerned as it is a lot less expensive and I wonder if I would get what I paid for...

So figured it made sense to ask around. Thanks for any experiences shared!
 
Yes, I have one, and it has been reliable so far. It takes about 60 seconds to power up. The highest reading I’ve observed in any of my fills was 0.2 ppm. When I first received the unit, I experimented with it and was able to get readings as high as 10 ppm when positioned close to an exhaust source.


Additionally, the company was highly responsive when I reached out with questions about the optimal flow rate for accurate measurements.
 
Good review on its big brother.
 
We have one and I agree with the comments above about both the product and the company. Measuring CO is slower than measuring O2 (for Nitrox) but it does work and is rugged enough for dive travel.
 
Thanks for the responses, I think I'll give it a try.

@NachoMan, curious about the optimal flowrate. I have a flow limiter I use for my Nitrox analyzer, do you use a similar device to test for CO? If so, does that work ok?

Thanks again!
 
Dr. Koz at FORENSICS DETECTORS recommends a flow rate between 0.1 and 0.3 LPM. Your unit should include a dome attachment with a restricted orifice that easily snaps on, helping to regulate pressure from the cylinder and preventing sensor damage. I use a quick-release connector with an output flow of 0.2 LPM—the same setup I use with my Divesoft He/O2 analyzer.
 

Back
Top Bottom