dtdiver
Contributor
my diverite lighthead has a plastic clamp that holds the head to the handle.
the problem is that the head pulls out of the clamp too easily.
i have an stainless steel hand mount, but i can't figure out how to secure it.
i do not have a zip tie long enough without drilling the plastic or the handle, even then it may not be long enough.
any suggestions?
i would post a pic but don't know how so see this link.
http://diverite.com/products/lights/hand_mnt.htm
dt
the problem is that the head pulls out of the clamp too easily.
i have an stainless steel hand mount, but i can't figure out how to secure it.
i do not have a zip tie long enough without drilling the plastic or the handle, even then it may not be long enough.
any suggestions?
i would post a pic but don't know how so see this link.
http://diverite.com/products/lights/hand_mnt.htm
dt
