I've acquired an older version of a USD Conshelf . It has been unused for a long time and did not appear to have had much use. During a rebuild, with the "fingernail test", it seemed to have an almost imperceptible nick in the crown which is non replaceable on this model.
I decided to assemble it and see if it would seat in. I did, and adjusted fine on a 500psi tank, but on a full tank the intermediate pressure creeps.
Anyone have a method to save this first stage?
Thanks,
I decided to assemble it and see if it would seat in. I did, and adjusted fine on a 500psi tank, but on a full tank the intermediate pressure creeps.
Anyone have a method to save this first stage?
Thanks,