Atomic Subframe Lens Replacement

[Daebado]

I have an Atomic Subframe mask that I want to replace the lenses in. I have the new lenses but can't seem to find anything in here or on the internet that shows how to replace them. I could just start having at it but I don't want to make a wrong move and ruin the mask.
Thanks.

 

[C Bravo]

Hello !
Exact same question here. I have bought the Atomic Subframe Mask specifically because it says you can replace the lenses. I bought reading lenses for the mask. Did you get any helpful replies?

 

[Daebado]

Hello !
Exact same question here. I have bought the Atomic Subframe Mask specifically because it says you can replace the lenses. I bought reading lenses for the mask. Did you get any helpful replies?

No, I ended up just tearing into it and it ended up being fairly straight forward. I wouldn't say "easy" but do-able. You just have to make sure everything snaps back into place when you put it back together. One of my lenses leaked badly when I first jumped in the water after changing them out. I was able to put some pressure on them where the leak was and actually heard it snap into place. No more leak after that!

 

[Aquaviolator]

Perfect timing, friend was asking me if I knew anything about changing this out a few days ago. Thanks!

 

[Daebado]

Any time! I have had more than my share of help from others in this forum. Nice to be able to give back a little!

 

[tridacna]

After you replace the lenses, squirt a little soapy water on the inside of the mask. Then blow some compressed air on the outside. Any leaks will make bubbles -- if you see them, you will then have to re-seat the lenses.

 

[Daebado]

Certainly better than the way I did it:

Put on mask. Jump in. If the mask fills up with water, you have a leak!

 

[tridacna]

Certainly better than the way I did it:

Put on mask. Jump in. If the mask fills up with water, you have a leak!

I used to do it for customers. Your method "may" have been problematic.

 

[nightfish]

Any tips on where or how to start taking the mask apart?

 

[happy-diver]

the bridge falls off mate after you undo the allen, t10 screw ish from inside the mask
and everything else falls to pieces after that

I use water as a lube to reassemble
and make sure the hair falling out of my head lands on the floor

Simplest mask ever