Apeks reg identify

[willianstr1ker]

can someone help me identify this reg setup?

There is a local guy selling it, I'm looking into using it for a stage bottle, it is possible to convert this first stage into a ds-4 to get the environment seal to dive in colder water?

 

[Tanks A Lot]

Your first stage is a AT20 or T20, sometimes called US4 (Unsealed 4).

Your second stages are Apeks ATX40. With a plastic heat-exchanger these would be called AT20.

 

[runsongas]

yes it is possible to convert, but it requires a few pieces and the cost is not going to make sense vs just looking for a used din ds4

 

[Tanks A Lot]

I completely missed the question about changing it to a DS4. This can of course be done quite easily.

The parts needed are:

• AP1473 - Diaphragm Clamp
• AP1483 - Hydrostatic Transmitter
• AP1482 - Hydrostatic Diaphragm
• AP1484 - Environmental Cap

 

[runsongas]

don't forget the din conversion kit AP0211 or DIN handwheel/connector AP1470/AP1471 as the pictured us4 is also yoke

 

[willianstr1ker]

Thank you all for the help. I’m going to go ahead and get the reg setup, is there a site you recommend to buy the parts needed?

 

[Tanks A Lot]

I know that ScubaFreaks and M&A Malta usually have these parts. There are a few more shops one could easily get these from in Europe as well. I'm not sure where I would source them in the US.