Aeris Atmos Pro and Cold Water?

[H2ODiver]

I have emailed Aeris several times with no response so I thought I would ask the question here.

Does anyone know what the rating is for the Atmos Pro regulator and cold water diving?

Thanks,

Chris

 

[hunter991]

Not sure I understand your question? Are you asking what sort of water temperature the regulators is safe to? I will get you an answer as soon as I understand the question....just let me know buddy.

Brent

 

[darylm74]

I have had my Aeris Atmos Sport down in 42 degree water with no issues. It is lower on the scale than the pro

 

[H2ODiver]

Darylm74 - Thanks for the feedback. It is nice to know the reg can go to 42 degrees without a problem.

Brent - If you have the specs on how cold the water can be before problems occur with this regulator that would be great.

I do not plan on diving in extreme cold water but it's nice to know what the capabilities of this reg is.

Thanks for your help!

 

[cerich]

Depending on you technique it'll work in water in the 30's no worries.

 

[H2ODiver]

Cerich,

Thanks for the feedback... what do you mean my technique?

Thanks

 

[scubatoys]

We called the guys at Aeris and they are pulling the official specs! But as stated above the mid 30s for the Aeris Atmos Pro should be no problem.

I will post the specs as soon as they get back with me.

 

[H2ODiver]

Thanks Scubatoys for your help.

Your customer service has always been top notch when purchasing from you guys...
Thanks for stepping up to the plate once more to help out a fellow diver.

Looking forward to any concrete specs you may find out from Aeris.

Thanks again!

 

[hunter991]

This isn't regulator specific but it applies for most regs in cold water use. I wouldn't test breathe the regulator out of the water, or purge it out of the water to see if your reg is working. That could cause freezing. I also wouldn't do long purges anytime the water is below 30.

Brent

Cerich,

Thanks for the feedback... what do you mean my technique?

Thanks

 

[H2ODiver]

Brent,

Thanks for the info.