Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
Snort new keyboard pleasecancun mark:Here it is as explained to me by a Honduran fisherman.
Open first stage with large spanner or pipe wrench.
Remove HP seat with fishook
Turn over HP seat unless this has been done before. Wack the piston against the side of the boat to force the seat into the piston.
If the seat has already been turned, find a used plastic oil can or something similar, use the piston as a hole punch to punch out small bits of plastic, repeat as neseccary until the plastic fills the hole.
spit on the piston to remove excess motor oil.
reassemble and put back into rental service.
Hope that helps, before you use this method, I would check the warranty on you reg to see if this invalidates it.
Old&Cold:Hi,
I was wondering if anyone had a repair manual for the Sherwood Brut?
Thanks
Thank you.Marek K:
Scuba Tech:If you need a manual for a Brut, take up golf!
P.S. Red 5 gal gas can best for HP seat!!!