Squeezelock mounting pieces

Mr Grinch · 2025-07-04T21:43:10-0400

This is the last of the measurements including the shaft of the screw to obtain nut insert size

lairdb · 2025-07-04T23:54:28-0400

What’s the thickness when including the raised island?
What’s the threading?

Mr Grinch · 2025-07-05T03:29:52-0400

lairdb:
What’s the thickness when including the raised island?
What’s the threading?

The thickness with the raised Island is in the pic included above your reply (it only allows me 5 pics per post) as for the thread pitch, my gauges are at work I’ll bring one of the screws in and get that info. But the other pic in the second post gives the shaft size which should narrow the pitch down to two. One for fine and one for coarse.

lairdb · 2025-07-05T13:23:42-0400

Mr Grinch:
The thickness with the raised Island is in the pic included above your reply (it only allows me 5 pics per post) as for the thread pitch, my gauges are at work I’ll bring one of the screws in and get that info. But the other pic in the second post gives the shaft size which should narrow the pitch down to two. One for fine and one for coarse.

Got it; missed your second post.

Fastener could be an M4 but some of the other dimensions seem to be inch-derived, and you measured at the shoulder, so I'd bet it's an ANSI #6. Did some rounding estimation assuming the engineers were inch-people.