Langdon Stevenson
Registered
Hi,
I recently purchased a 200DL Ikelite housing for a Canon 80D. While loading the camera into the housing for the first time - having already connected the TTL hot shoe connector, the camera slipped backwards and wrenched the wiring in the hot shoe connector. Two of the wires (the blue and red) were torn from their solder beds. The white, green and orange are still attached as shown below.
I am experienced with electronics and soldering and am comfortable re-soldering the wires - however it is only 80% clear which wire should be attached to which pad on the hot shoe circuit board.
Would it be possible to provide a wiring diagram for this component to allow me to affect repairs?
I am due to travel with this housing very soon, so returning the housing for repair is not an option unfortunately.
Any assistance you can provide would be greatly appreciated.
Langdon
I recently purchased a 200DL Ikelite housing for a Canon 80D. While loading the camera into the housing for the first time - having already connected the TTL hot shoe connector, the camera slipped backwards and wrenched the wiring in the hot shoe connector. Two of the wires (the blue and red) were torn from their solder beds. The white, green and orange are still attached as shown below.
I am experienced with electronics and soldering and am comfortable re-soldering the wires - however it is only 80% clear which wire should be attached to which pad on the hot shoe circuit board.
Would it be possible to provide a wiring diagram for this component to allow me to affect repairs?
I am due to travel with this housing very soon, so returning the housing for repair is not an option unfortunately.
Any assistance you can provide would be greatly appreciated.
Langdon